Carrier compatibility
A stable COF in thin LDPE film, without the haze you get from over-dosing slip alone.
Typical values for the standard version. Tolerances and test methods are listed in the TDS.
Erucamide slip combined with a narrow particle-size silica antiblock. The combination gives a stable coefficient of friction without the bloom haze you get from over-dosing slip alone.
| System | Erucamide + natural silica |
| Typical dose | 1 – 2 % |
| COF | Set by dose, agreed at trial |
| Haze increase | Set by dose, agreed at trial |
| Slip type | Hot slip, fast bloom |
| Carrier | PE / LDPE / LLDPE / PP / EVA |
Typical values, for reference only — not a specification and not part of any contract. What binds us is the specification confirmed in writing on your order, and where a sample has been approved, that sample governs. Send us your resin, process and target value and we will confirm the exact figure before you set a production parameter.
Common to every grade we make. Where a grade differs — active content, carrier, colour — the difference is stated on its own data sheet.
| Appearance | Free-flowing pellets |
| Active content | 15 – 30 % (grade dependent) |
| Moisture | ≤ 0.10 % |
| Volatiles | ≤ 0.30 % |
| Agglomerates | ≤ 3 per 1,000 g |
| Heat stability | Grade dependent — see grade data sheet |
| Bulk density | 0.55 – 0.75 g/cm³ |
| Packing | 20 kg PE bag · 25 kg on selected grades |
| Shelf life | 12 months, sealed and dry |
The table above describes the grade family. The figures for your lot are on the COA that travels with it, and the release value is measured on that batch.
If your part is not listed, send a drawing or a photo — we have probably run something close.
Stable COF for high-speed bag machines.
Low haze, no blocking on the roll.
Fast slip development.
Grade documents are issued per grade and travel with the lot. ISO 9001 / ISO 14001 are held by our production site, not by the grade.
FOB Ningbo to any port. We can book the vessel and handle the documents if you prefer.
Slip lowers friction between film surfaces, antiblock stops them sticking. Most thin film lines need both; send us your thickness and we will set the ratio.
At the recommended dose the surface tension is unaffected. Above that we recommend a corona retreatment check.
Tell us the resin, the process and the target performance. You get a grade recommendation, a landed cost to your port and a sample plan.